Gigabyte GA-EP45-UD3P User Manual page 89

Step 5:
Enter the array capacity and press <Enter>. Finally press <Enter> on the Create Volume item to begin creat-
ing the RAID array. When prompted to confirm whether to create this volume, press <Y> to confirm or <N> to
cancel (Figure 6).
[ hi ]-Change
When completed, you can see detailed information about the RAID array in the DISK/VOLUME INFORMA-
TION section, including the RAID level, stripe block size, array name, and array capacity, etc. (Figure 7)
1. Create RAID Volume
2. Delete RAID Volume
RAID Volumes :
ID Name
0 Volume0
Physical Disks :
Port Drive Model
0 ST3120026AS
1 ST3120026AS
[ hi ]-Select
To exit the ICH10R RAID BIOS utility, press <Esc> or select Exit in MAIN MENU.
Now, you can proceed to create the SATA RAID/AHCI driver diskette and install the SATA RAID/AHCI
driver and operating system.
Intel(R) Matrix Storage Manager option ROM v8.0.0.1039 ICH10R wRAID5
Copyright(C) 2003-08 Intel Corporation. All Rights Reversed.
[ CREATE VOLUME MENU ]
RAID Level : RAID0(Stripe)
WARNING : ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N) :
Press ENTER to create the specified volume.
[TAB]-Next
Intel(R) Matrix Storage Manager option ROM v8.0.0.1039 ICH10R wRAID5
Copyright(C) 2003-08 Intel Corporation. All Rights Reversed.
[ DISK/VOLUME INFORMATION ]
Level
RAID0(Stripe)
Serial #
3JT354CP
3JT329JX
Name : RAID_Volume0
Disks : Select Disks
Strip Size : 128KB
Capacity : 223.6 GB
Create Volume
[ HELP ]
[ESC]-Previous Menu
Figure 6
[ MAIN MENU ]
Strip Size
128KB 223.6GB
Size
111.7GB
111.7GB
[ESC]-Exit
Figure 7
- 89 -
[ENTER]-Select
3. Reset Disks to Non-RAID
4. Exit
Status Bootable
Normal Yes
Type/Status(Vol ID)
Non-RAID Disk
Non-RAID Disk
[ENTER]-Select Menu
Appendix