Gigabyte GA-EP45-UD3P User Manual page 100

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
For the Intel ICH10R: jk
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears, select Load Driver (Figure 4).
Step 2:
Insert the motherboard driver disk (Method A) or the floppy disk/USB flash drive that contains the driver (Method
B), then specify the location of the driver (Figure 5). Note: For users using a SATA optical drive, be sure to
copy the driver files from the motherboard driver disk to a USB flash drive before installing Windows Vista (go
to the BootDrv folder and save the whole iMSM folder to the USB flash drive). Then use Method B to load
the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\iMSM\32Bit
For Windows Vista 64-bit, browse to the 64Bit folder.
Method B:
Insert the USB flash drive containing the driver files and browse to \iMSM\32Bit (for Windows Vista 32-bit) or
\iMSM\64Bit (for Windows Vista 64-bit).
j Only for GA-EP45-UD3P.
k Only for GA-EP45-UD3R.
Appendix
Figure 4
Figure 5
- 100 -