Gigabyte GA-EP45-UD3P User Manual page 26

7) IDE (IDE Connector)
The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attach-
ing the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices,
remember to set the jumpers and the cabling according to the role of the IDE devices (for example,
master or slave). (For information about configuring master/slave settings for the IDE devices, read the
instructions from the device manufacturers.)
8) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10, Orange) l
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
l Only for GA-EP45-UD3.
Hardware Installation
SATA2_4 SATA2_2
7
7
SATA2_5 SATA2_3
- 26 -
40 39
2 1
Pin No.
SATA2_0
1
1
SATA2_1
Please connect the L-shaped end of
the SATA 3Gb/s cable to your SATA
hard drive.
Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND