Installing The Belt Clip; Installing The Optional Headset - Uniden DSS3405 Owner's Manual

Installing the Belt Clip

Line up the tabs with the holes on each side
of the handset. Press the belt clip down until
both tabs click into place. To remove the belt
clip, pull both sides of the clip to release the
tabs from the holes.

Installing the Optional Headset

Your phone may be used with an optional
headset. To use a headset, insert the headset
plug into the headset jack. Headsets may be
purchased by contacting Uniden. See
warranty on inside back cover for contact
information.
Charging the Accessory Handset
The handset is powered by a rechargeable battery pack that
automatically recharges when the handset is placed in the
charger.
1. Connect the AC adapter to
the DC IN 9V jack and to a
240V AC outlet that is not
controlled by a wall switch.
Caution: Use only the
Uniden AAD-600S adapter.
2. Set the charger on a desk or
tabletop, and place the handset in
the charger with the keypad facing forward.
3. Make sure that the charge
illuminate, check to see that the AC adapter is plugged in and
the handset makes good contact with the charging contacts on
the charging cradle.
4. Charge the handset battery pack for at least 15-20 hours before
using your new handset for the first time.
LED illuminates. If the LED does not
(3)