Checking the Package Contents Make sure you have received the following items in the package. If any of these items are missing or damaged, contact the Uniden Parts Department. Your DCX 490 will work with the following units: DCT 4960 DCT 4960-2...
Page 3
When the battery is charged, the LCD will display “ Initializing... for 5 to 10 seconds. Use only the Uniden battery (BP-490) supplied with your phone. Replacement batteries are also available through the Uniden Parts Department. (See page 2) ”...
Page 4
Battery use time (per charge) Fully charged • 6 hours continuous use • 3 days when the handset is in the standby mode Low battery alert When the battery pack is very low and needs to be charged, the phone is programmed to eliminate functions in order to save power.
Page 5
To set up additional handsets Follow the simple steps to register your new additional handset. Check that the phone is not in use (including the intercom), and make sure that the handset is not in the base unit. Press and hold the find handset key on the base for 5 seconds.
Changing the Digital Security Code The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary unless you are replacing an extra handset. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
(C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for...
Need help?
Do you have a question about the DCX 490 and is the answer not in the manual?
Questions and answers