Deleting An Outgoing Message; Setting The Base Ringer Volume - Uniden DSS 2475 Quick Start Manual

UP308BH (DSS2465) ENG OM 12/28/04
Choosing between the two outgoing messages
When the phone is in the standby mode, press
the outgoing message is played. Each time
is switched between the pre-recorded and the personal outgoing message.

Deleting an outgoing message

To delete the personal outgoing message, press
The system announces "Greeting has been deleted".

Setting the base ringer volume

You have four ringer volume options. One allows you to turn the base ringer off.
The other three are volume levels.
1) When the phone is in the standby mode, press
ringer at the current volume level (" " High, " " Medium, " " Low, or " " Off)
(if you set the base ringer volume to off "Ringer Off" is announced), and it appears
on the base.
2) Press /
L
will hear a ringer at the selected volume level. The system returns to the standby
mode.
You can also set the base ringer volume while the phone is ringing. Press
/ or repeatedly to select the desired ringer volume.
L M
8:25 AM Page 43
. Press
is pressed, the outgoing message
while the message is playing.
or repeatedly until the desired ringer volume appears. You
M
again when
/ or . You hear the • If an outside call is
L M
• If you press
received during this
operation, the
operation is canceled.
/
L
in the maximum
volume level (3) or
/
in
M
the ringer off (0), you
will hear a beep.
[ 43 ]