Table of Contents
Advertisement
2.6-C. CPU Front Side Bus Jumpers (J48, J49; J52, J53) (READ NOTE BELOW)
With these jumpers, the CPU FSB can be set to either 200 or 266MHz.
YOU MUST SET THESE JUMPERS FOR PROPER CPU OPERATION. If your
CPU can only run at 200MHz, altering these FSB jumpers will not make the
CPU run at 266MHz.
NOTE:
Tyan takes no reponsibility and will not be held liable for damage related to opera-
tion of the CPU using different settings from those of the CPU manufacturer's
specified default settings.
2.6-D. Front-side USB Header* (J36)
This header allows for a USB connection*. The USB channel on this header is on a separate channel
from the rear USB connections channel. USB v1.1 is supported on this board.
* Only certain chassis allow for frontside USB connection. Please check with your chassis vendor for
details on frontside USB connections. Tyan does not provide frontside USB cables.
Tiger MP S2460
You MUST set ALL FOUR JUMPERS to the
NOTE:
same speed. Damage may result otherwise!
266MHz
J52
2-3
J53
2-3
J48
1-2
J49
1-2
USB Header (J36)
+VCC
1 2
signal out
3 4
signal in
5 6
ground
7 8
ground
9 10
200MHz
1-2
2-3
2-3
2-3
ground
ground
signal in
signal out
+VCC
13
Advertisement
Table of Contents
