Tips For Using The Paper Feeder - Epson LQ 300 User Manual

Tips for Using the Paper Feeder

Following the tips below will give you the best performance
when printing with the paper feeder.
Load paper into the paper feeder before you turn on the
printer and send data. When the printer receives data from
the computer, it loads a single sheet automatically and
begins to print.
cl If the printer runs out of paper during a print job, reload
the paper feeder and then press the LOAD/EJECT button to
continue printing.
Press the LOAD/EJECT button if you need to eject a sheet of
cl
loaded paper.
0 You can switch to manual loading to feed single sheets or
envelopes without removing the paper supply from the
paper feeder. For instructions, see "Loading Paper
Manually" in Chapter 2.
cl Because most application programs take care of the top and
bottom margins, you should usually adjust the margins by
using your programs, taking the printer's default loading
position into account. You can change the default loading
position. See "Using the Default-Setting Mode" in Chapter
2.
The default page length for paper loaded from the paper
feeder is 61 lines (letter-size paper) and 65 lines (A$-size
paper). You can change it using your application program
or printer commands, if necessary. See the Appendix for
more about printer commands.
cl If the ink does not dry fast enough, try removing sheets one
at a time as they finish printing.
Setting Up Your Printer
1-23