Advertisement
Installation and Operation
1
2
3
4
5
6
201112150-93-3153.indd 3
Connect the HDMI source to the HDMI input on the local transmitter unit.
Connect the TMDS RJ45 port on the local transmitter to the TMDS
RJ45 port on the remote receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension
distance at 1080p (24 Hz) / 1080i (60 Hz) video resolutions.
Connect the DDC RJ45 port on the local transmitter to the DDC
RJ45 port on the remote receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension
distance at 1080p (24 Hz) / 1080i (60 Hz) video resolutions.
Connect the HDMI output on the remote receiver to the HDMI monitor.
Connect the external power supply to the remote receiver, and then
plug it into a Tripp Lite Surge Suppressor, Uninterruptible Power Supply
(UPS), or Power Distribution Unit (PDU). The Green LED on the remote
unit will illuminate to indicate that power is being received.
Turn on the power to the HDMI source.
Note: The Red LED on the Remote Receiver unit will illuminate only
if a working signal is NOT being received. The unit is functioning
properly when this LED is not illuminated.
3
1/4/2012 11:49:36 AM
Advertisement
