Removing The Printed Document From The Rear Push Tractor - Epson FX-1180 User Manual

10. After you finish printing, follow the steps in the next section
to remove your printed document.
If the first line on your page appears too high or low, you can
change its position using the micro adjust feature as described
in "Adjusting the Top-of-Form Position" on page 3-35.
Caution:
c
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Removing the printed document from the rear push
tractor
To remove the printed document, follow the steps below.
1. Press the Tear Off/Bin button to feed the paper's perforation
to the tear-off edge of the printer cover.
Note:
If your paper's perforation is not properly aligned with the tear-off
edge, you can adjust the tear-off position using the micro adjust
feature. See "Adjusting the tear-off position" on page 3-38.
2. Tear off the printed document using the tear-off edge of the
printer cover.
3. To feed the continuous paper backward out of the printer and
into the standby position, press the Load/Eject button.
To remove the remaining paper from the printer, press the
Load/Eject button to feed the paper backward to the standby
position. Then open the sprocket covers of the tractor and
remove the paper.
3-18
Printing on Continuous Paper