Threading The Upper Thread; Adjusting The Stitch Length - Brother SL-1110 Instruction Manual

6. PREPARATION BEFORE SEWING

6-5. Threading the upper thread

Turn off the power switch before threading the upper thread.
The motor will keep turning even after the power is switched off as a result of the motor's inertia. Wait until the
motor stops fully before starting work.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
3850M

6-6. Adjusting the stitch length

11
CAUTION
Turn the machine pulley and raise the thread take-up (1)
before threading the upper thread.
This will make threading easier and it will prevent the thread
from coming out at the sewing start.
Turn the stitch length dial (1) until the desired stitch length
number is aligned with the pin (2) above the dial.
The larger the number, the longer the stitch length will be.
(The numbers on the dial are for use as a guide. The
length of the finished stitches may vary depending on the
type and thickness of material being sewn. Adjust while
looking at the finished stitches.)
When turning the stitch length dial (1) from a larger
setting to a smaller setting, it will be easier to turn the dial
if the reverse lever (3) is pushed to the halfwaydown
position.
3851M
SL-1110