Table of Contents
Advertisement
Date (mm:dd:yy)
Sets the system date.
Time (hh:mm:ss)
Sets the system time.
IDE Channel 0, 1, 2, 3 Master
IDE HDD Auto-Detection, IDE Auto-Detection
Press <Enter> to autodetect the parameters of the SATA device on this channel.
IDE Channel 0, 1 Master, Extended IDE Drive
Configure your SATA devices by using one of the three methods below:
Lets the BIOS automatically detect SATA devices during the POST. (Default)
• Auto
If no SATA devices are used, set this item to None so the system will skip the
• None
detection of the device during the POST for faster system startup.
Allows you to manually enter the specifications of the hard drive when the hard drive
• Manual
access mode is set to CHS. (For IDE Channel 0, 1 Master only.)
Access Mode
Sets the hard drive access mode. (Default: Auto)
The following fields display your hard drive specifications. If you wish to enter the parameters manually,
refer to the information on the hard drive.
Capacity
Approximate capacity of the currently installed hard drive.
Cylinder
Number of cylinders.
Head
Number of heads.
Precomp
Write precompensation cylinder.
Landing Zone
Landing zone.
Sector
Number of sectors.
Halt On
Allows you to determine whether the system will stop for an error during the POST.
Options are: "All Errors," "No Errors," "All, But Keyboard" (default), "All, But Diskette," "All, But Disk/Key."
Memory
These fields are read-only and are determined by the BIOS POST.
BIOS Setup
- 24 -
Advertisement
Table of Contents
