Epson DLQ-3500 Setup Manual page 26

If you use an extension cord with the printer, make sure the
total ampere rating of all devices plugged into the extension
cord does not exceed the cord's ampere rating. Also, make
sure the total ampere of all devices plugged into the wall
outlet does not exceed the wall outlet's ampere rating.
Unplug the printer before cleaning it, and always clean it with
a piece of damp cloth only.
Replace fuses only with a fuse of the correct size and rating.
Do not spill liquid onto the printer.
Except as specifically explained in this guide, do not attempt
to service the printer yourself.
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
i. If the power cord or plug is damaged.
ii. If liquid has entered the printer.
iii. If the printer has been dropped or the cabinet damaged.
iv. If the printer does not operate normally or exhibits a
distinct change in performance.
If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this printer, the building
installation must be protected by a 10- or 16-amp circuit
breaker.
Note for German-speaking users:
Bei Anschluss des Druckers an die Stromversorgung muss
sichergestellt werden, dass die Gebaudeinstallation mit einer 10 A-
oder 16 A-Sicherung abgesichert ist.
24
Safety and Environmental Information