Sony Handycam CCD-TR42 Operation Manual page 42

AC Power Adaptor
Symptom Cause CorrectiveActions _ page
The POWER lamp does not Set the selector to the center position and
_. light, disconnect the power cord. After about 7
o I -- one minute, reconnect the power cord and
o. set the selector to CHARGE again.
< _ The CHARGE lamp flashes. See the following chart.
When the CHARGE Lamp Flashes
Check through the following chart.
Remove the battery pack from
the AC power adaptor.
If the CHARGE lamp flashes
again, install another battery
pack.
-_i Install the same battery pack again.
If the CHARGE lamp lights up and
goes out after a while, the battery pack
is operating correctly.*
The CHARGE lamp lights up.
CHA C amp hashes.
If the CHARGE lamp goes out after a
while, the problem is with the battery
pack firstly installed.
The problem is with the AC power
adaptor.
Please contact your nearest Sony dealer.
* If you use a battery pack which you have just bought or which has been left unused for a long time, the
CHARGE lamp may flash at the first charging. But this is not a problem. Repeat again to charge with
the same battery pack.
42