Speaker System Hookup - Sony SAVA-D900 Operating Instructions Manual

Speaker System Hookup
u:
_h
®
1 Use an optional CONTROL S cord to connect the
CONTROL S IN jack on the left main unit to the
CONTROL S OUT jack on the back of the TV.
XBR 2 seriesTV set or
Projection TV
Main unit (left)
(Not supplied)
2 Follow the Operating Instructions supplied with your
TV set to set it to operate this speaker system.
"_" If you use the S-video connector instead of the video jack
Your TV must also be connected via an S-video connector. S-
video signals are on a separate bus from the video signals and
will not be output through the video jack.
Connecting the FM/AM antennas
Set up the AM loop antenna, then connect it.
AM loop antenna
!
Extend the FM lead antenna horizontally.
Notes
• To prevent noise pickup, keep the AM loop antepala
away from file system and other components.
• Be sure to fully extend the FM wire antenna.
• After connecting the FM wire antenna, keep it as
horizontal as possible.
• When you connect the supplied AM antenna, connect
the black cord (A) to the rh terminal, and the white cord
(B) to the other terminal.
Connecting the AC power cord
Connect the AC power cord from the left main unit to a
wall outlet.
With its built-in amplifier, this speaker system can be used
to output audio and video signals directly from such
components as LD players, MD decks, digital satellite
receivers, and VCRs.
If you connect a VCR
Connect the VCR to the AUDIO L/R and VIDEO jacks of
VIDEO INPUT of file system.
Main unit (left)
.z2=
VIDEO
l ,.PUT J
VCR
AUDIO L VJDEO
If you connect an LD player, another VCR, or
other video components
Connect the component to the AUDIO L/R and VIDEO
jacks of AUX of the system.
Main unit (left)
LDplayer, another VCR, etc.
R AUDIO L VIOEO
@@@Ioo,,uq
I- ,_, T
__?
12