Advanced
Operations
You can choose any of the following
power
sources for your camcorder: battery pack (p. 6), house
current, and 12/24 V car battery. Choose the appropriate power source depending
on where you want
to use your camcorder.
.........
A esso-s tobeused
Place
Power source
•
Indoors
House current
AC-V25/V25A
AC power adaptor (supplied),
AC-S10, AC-V55
Outdoors
Battery pack
NP-55 Battery pack (supplied), NP-80/80D,
NP-77H,
NP-66H,
NP-60D, NP-55H
In the car
12 V or 24 V car battery
DCP-77 DC pack
To use the supplied AC-V25/V25A
AC power
adaptor:
(1) Lift up the viewfinder.
(2) Connect
the AC power
cord to a wall outlet. Connect
the bottom
of
the AC power adaptor
to the battery
mounting
surface of the camcorder. (3) Set the selector to
VTR (DC OUT).
3
Note on the POWER lamp
• ThePOWER
lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
• If the POWER
lamp does not light, set the selector to the center position and disconnect
the power
cord. After about one minute, reconnect
the power cord and set the selector to VTR (DC OUT)
again.
To remove the adaptor
The adaptor
is removed
in the same way as the battery
pack. (p. 8)
"4
m
-4
a,
_.
-'i
21