Setting Up The Channel List; Using Auto Program - Sony FD Trinitron WEGA KV-34HS420 Operating Instructions Manual

Setting Up the Channel List
After you finish connecting your TV, you need to run Auto Setup to
set up your channels. The Auto Program screens appear when you
turn on your TV for the first time after hooking it up.
Using Auto
Program
_I_ Toexit the Tilt Correction
and VerticalCorrection
screens,pressthe MENU
button.
For more details on using
Auto Program, see page 52.
For more details on using Tilt
Correction and Vertical
Correction, see page 59.
Torun Auto
Program
the first timeyou turn on your TV
1
Press POWER to turn on the TV.
The Initial Setup screen appears.
2 Press tt _, to move the highlight to the desired language, then
press (_ to select that language.
3 The next screen instructs you to connect your cable/antenna.
Check that you've connected your signal source properly.
To start Auto Program, highlight Yesand then press (_.
Auto Program automatically creates a list of receivable channels.
_vVhenAuto Program is finished, the Tilt Correction screen
appears.
4 Press _. * to correct any tilt of the picture. You can choose a
correction between +7 and -7.
_vVhen finished, press @.
5 _ The Vertical Correction screen appears. Press tt
_, to make a vertical correction to the picture. You can choose a
correction between +5 and -5. When finished, press @.
_vVhencompleted, the lowest numbered channel is displayed.
Toreset the IV to
factory settings
1
Press POWER t o turn on the TV.
2 Hold down RESET on the remote control.
3 Press TVPOWER on the TV. (The TV will turn itself off, then back
Oil.)
4
Release RESET.