Sony STR-DE485 Operating Instructions Manual page 30

After you have tuned in stations using Direct
Tuning or Automatic Tuning, you con preset
them to the receiver. Then you can tune in any
of the stadons directly by entering its 2-
character preset code using the supplied
remote. Up to 30 FM or AM stations can be
preset. The receiver will also scan all the
stations that you have preset.
Before tuning to preset stations, be sure to
preset them by performing steps on "Presetting
radio stations" in this page.
Presetting radio stations
1
Press TUNER.
The last received station is tuned in.
2
Tune in the station that you want to
preset using Direct Tuning (page 29) or
Automatic Tuning (page 29).
3 Press MEMORY.
"MEMORY" appears in the display for a few
seconds.
Do steps 4 to 6 before "MEMORY" goes out.
4
Press SHIFT to select a memory page
(A, B or C).
Each time you press SHIFT, the letter "A",
"B', or "C" appears in the display.
5 Press PRESET TUNING + or PRESET
TUNING - to select a preset number.
If "MEMORY" goes out before you press
the preset number, start again fi'om step 3.
6
Press MEMORY again to store the
station.
If "MEMORY" goes out before you can
store tbe station, start again from step 3.
7
Repeat steps 2 to 6 to preset another
station.
To change a preset number to
another station
Do steps 1 to 6 to preset a new station to the
number.
Tuning to preset stations
You can tune the preset stations by eitber of the
IMIowing two ways.
Scanning the preset stations
1
Press TUNER.
The last received station is tuned in.
2 Press PRESET TUNING + or PRESET
TUNING - repeatedly to select the
preset station you want.
Each time you press the button, the receiver
tunes in one preset station at a time, in the
corresponding order _md direction as
follows:
_A1+-_A22_021.c_B +I C_12 ..... B0_]
Using the preset codes
Use the supplied remo_e to perform the
l_llowing operations. For details on the buttons
used in this section, see pages 34-37.
1 Press TUNER on the remote.
The last received station is tuned in.
2
Press SHIFT to select a memory page
(A, B, or C), then press the preset
number of the station you want using
the numeric buttons.
30G8