Sony STR-DE485 Operating Instructions Manual page 29

Before receiving broadcasts, make sure you
have connected FM and AM antennas to the
receiver (page 7).
You can enter a frequency of the station you
want directly by using the numeric buttons on the
supplied remote. For details on the buttons used
in this section, see pages 34-37.
t Press TUNER on the remote.
The last received st_tion is tuned in.
2 Press FM or AM to select the FM or AM
band.
3 Press D.TUNING on the remote.
4 Press the numeric buttons to enter the
frequency.
ExampleI : FM 102.50 MHz
(9-®*®o®o®
Example 2: AM 1350 kHz
(You don't have to enter the last "I)" when the
tuning scale is set to 10 kHz.)
(9-®o®-®
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right
frequency. If not, repeat steps 3 and 4.
If the entered numbers still flash, the
frequency is not used in your area.
5 If you've tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
5 Repeat steps 2 to 5 to receive another
station.
Tips
• If you do not remember the pl_cise frequency, pl_ss
TUNING + or TUNING after entering tile value
close to the frequency you want. The receiver
automatically tunes ill the station you want. If tile
frequency seems to be higher than the entel_d value,
pl_ss TUNING +, and if the frequency seems m be
lower than the entered value, press TUNING -.
• If "STEREO" flashes in tile display and the FM
slereo reception is poor, pl_ss FM MODE to change
m monaurN (MONO). You will not be _ble m enjoy
the stel_o effect, but the sound wil! be less distorted.
To return to slereo mode, press FM MODE again.
The tuning scale is:
FM : 50 kllz
AM : 9 kHz
If you don't know the t?equency of the station
you want, you can let the receiver scan all
available stations in your *wea.
t Press TUNER.
The l_rst received station is tuned in.
2 Press FM or AM to select the FM or AM
band.
3 Press TUNING + or TUNING -.
Press TUNING + to scan from low to high;
press TUNING- to scan from high to low.
The receiver stops scanning whenever a
station is received.
When the receiver reaches either end of
the band
Scanning is repeated in the same direction.
4
To continue scanning, press TUNING +
or TUNING - again.
o
W
It.
I'1
II
29 GB