Troubleshooting; Specifications - Sony CDP-CE105 Operating Instructions Manual

Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
,,,kCheck that the player is connected securely.
•,_Make sure you operate the amplifier correctly.
The CD does not play.
•,_There's no CD inside the player ("no dISC"
appears). Insert a CD.
,,_Place the CD with the label side up on the disc
tray correctly.
,,,bClean the CD (page 11).
•,_Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (page 2).
The player functions incorrectly.
--I_The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Specifications
Compact disc player
Laser
Laseroutput
Semiconductor laser (X= 780 nm)
Emission duration: continuous
Max 44.6 pW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequencyresponse 2 Hz to 20 kHz + 1.0 dB
Signal-to-noise ratio More than 100dB
Dynamicrange More than 96rib
Harmonicdistortion Lessthan 0.01%
Channelseparation More than 86dB
Output
Jack Maximum Load
type output impedance
level
LINE OUT Phono 2 V Over 10 kilohms
jacks (at 50 kilohms)
General
Power requirements
Wherepurchased
USA
Australia
Power requirements
120 V AC, 60 Hz
240 V AC, 50/60 Hz
Power consumption
• Dimensions (approx.)
(w/h/d)
Mass (approx.)
Suppliedaccessories
10W
&30 x 135 x 400 mm
(17x 5 3/8 x 15 3/4 in.) incl. projecting
parts
4.5 kg (9 lbs 15 oz)
Audio cord (2 phono plugs - 2 phono plugs) (1)
Design and specifications are subject to change without notice.
12