Play); Notes On Cds - Sony CDP-CE105 Operating Instructions Manual

5 To program other discs or tracks, do the following:
To program Repeat Step(s)
Other discs 2
Other tracks on the same disc 3 and 4
Other tracks on other discs 2, 3 and 4
6
Press _>ll
to start Program Play.
To cancel Program Play
Press CONTINUE.
"_° You can create your program while checking the disc
labels
When the front cover is open, follow Steps I to 6 while
pressing DISC SKIP to check the disc labels.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
remains after
_The program even
Program Play ends
When you press [_11, you can play the same program
again.
"_" The program remains until you erase it or turn off the
_qr
player
If you exchange discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the program, and the rest of the program is
played in the programmed order.
Note
The total playing time doesn't appear when:
--You have programmed a track whose number exceeds 20.
--The total playing time of the program exceeds 200 minutes.
--Front cover is opened.
Notes on CDs
On handling CDs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the disc,
Not this way
• Do not expose the disc to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• DO not use any commercially available stabilizer. If you do,
the disc and the player may be damaged.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the disc from the center out.
• Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for vinyl
LPs.
Changing the track order
You can change your program before you start playing.
To Press
Erase the last step in the
program
• . Each time you press the
button, the last step will be
cleared.
Change the whole program
completely
• until "ALL CLr" appears
in the display. Create a new
program following the
programming procedure.
11