Sylvania LC200SL8 Owner's Manual page 26

Although the default code"0000" issupplied with the unit, you can set
your own password.
Use [Cursor A/V] to select"CHANGE PASSWORD", then
press [ENTER].
or
e.g.) digital TV mode
V - CHIP SETUP-
W RATING
MPAA RATING
DOWNLOACABLERATING
CHARGE PASSWORD
Press [the Number buttons]
on the remote control to
enter the new 4-digit password.
• Enter password again in "CONFIRM PASSWORD:'
space,
0_ _¸
NEW PASSWORD
CONFIRM PASSWORD
Press [SETUP] to exit.
Note:
• Make sure new password and confirm password must be
exactly the same. If they are different, the space is cleared
for reentering.
• Your password will be erased and return to the default
(0000) when a power failure occurs. If you forget the
password, unplug the power cord for 10 seconds to restore
the password to 0000.
EN