Using Your Headset - TomTom RIDER Manual

Cardo scala-rider™ headset
A Microphone
B On/Off button
C Speaker
D LED
E Volume down
F Volume up
G Charging connector
Before you can use your Bluetooth headset, fully charge the headset using the
charger supplied with the headset.
Note: Make sure you use the correct charger. There are different chargers for
your TomTom RIDER and your headset. Using the wrong charger may
damage the device.
To fully charge the headset takes between 2 and 3 hours. When charging, the
LED is a steady red. When charging is finished, the LED turns off.
When the batteries are running low, an alert tone is played.

Using your headset

To turn the headset on, press and hold the on/off button for 6 seconds, until
the LED flashes blue 3 times. An ascending alert tone is played. When the
headset is on, the LED flashes blue every 3 seconds.
To turn the headset off, press and hold the on/off button for 3 seconds, until
the LED flashes red 3 times. A descending alert tone is played.
If you did not establish a Bluetooth connection between your Bluetooth
headset module and your TomTom RIDER when you first turned your RIDER
on, you can establish the connection at any time.
From the Main Menu, tap Change Preferences. Tap Connect to headset and
follow the instructions to establish the connection.
Attach your headset to your helmet as shown in the Installation Poster. Make
sure you position the microphone correctly. For best results, don't position the
microphone directly in front of your mouth, position it just to the side of your
mouth.
A
B
D
C
E
F
G
5