TomTom RIDER Manual page 4

Hide thumbs Also See for RIDER:

Table of Contents

Using your TomTom RIDER

Switching on

1. Open the compartment on the bottom of your TomTom RIDER.

2. Push the memory card into the memory card slot.

3. Press and hold the On/Off button for 2 seconds, or until your

TomTom RIDER starts.

The first time you switch on your TomTom RIDER, it may take up to 20

seconds to start. To switch off your TomTom RIDER, press and hold the On/

Off button for 2 seconds.

Setting up

First, you have to answer a few questions to set up your device and your

Cardo scala-rider™ headset. Answer the questions by tapping the screen. You

will use the touchscreen for everything you do with your TomTom RIDER.

Follow the instructions to establish a Bluetooth connection between your

TomTom RIDER and your Cardo scala-rider™ headset.

Once you have answered the questions, your TomTom RIDER will display the

Driving View.

The screen is shown in black and white until your TomTom RIDER locates

your current position.

Charging your TomTom RIDER

Before you use your RIDER for the first time, it's a good idea to charge it fully

using the home charger, which takes about 2 hours.

There is no charging light on your RIDER. To check the battery status and see

when your RIDER is charging, switch on your device and tap the bottom right-

hand corner of the screen in the Driving View. The battery status is shown on

the next page.

Table of Contents