Removing the Touchpad Module
1. Perform the
"Removing the Lower
2. Perform the
"Removing the Battery
3. Release the connector latch (1) from the mainboard, then disconnect the touchpad cable (2).
Figure 3-31. Touchpad Cable
4. Release the connector latch (1) from the touchpad board, then disconnect the touchpad
cable (2). Detach the cable from the upper case assembly (3).
Figure 3-32. Touchpad Cable Self Adhesive Tape
3-22
Case" procedure described on page 3-7.
Pack" procedure described on page 3-8.
0
Machine Maintenance