Canon PowerShot G1 X User Manual page 92

Using an Eye-Fi Card
transfer.
Choosing o_ mode will interrupt the Eye-Fi connection. Although the Eye-Fi
connection wilt be restored after you choose another shooting mode or enter
Playback mode, the camera may transfer any movies made in ,_ mode again.
_ Checking Connection information
Check the access point SSID used by the Eye-Fi card or the connection
status, as needed.
Press the
MENU
button, choose [Eye-Fi
Settings] on the _'T tab, and then press the
@ button.
Choose [Connection info], and then press the
@ button.
The connection information screen is
displayed.
_Disabling Eye-Fi Transfer
Configure the setting as follows to disable Eye-Fi transfer by the card, if
necessary.
Choose [Disable] in [Eye=Fi trans.].
Press the
MENU
button, choose [Eye-Fi
Settings] on the _'T tab, and then press the
@ button.
Choose [Eye-Fi trans.], and then choose
[Disable].
(_ [Eye-Fi Settings] is not shown unless an Eye-Fi card is in the camera
with its write-protect tab in the unlocked position. For this reason, you
cannot change settings for an inserted Eye-Fi card if the write-protect
tab is in the locked position.
213