Toyota 2005 CAMRY Wiring Diagram page 112

System Outline
The automatic light control system works when the light control SW is turned to AUTO. The automatic light control sensor
detects the brightness around the vehicle. By this function, the system automatically turns the taillight and headlight on if the
brightness is below the regular level and turns the taillight and headlight off when the surroundings become brighter than the
regular level.
Service Hints
Body ECU
9–Ground : Approx. 12 volts with the ignition SW at ON or ST position
12, 24–Ground : Always continuity
1–Ground : Always approx. 12 volts
D6 Door Courtesy SW Front LH
1–Ground : Continuity with the driver's door open
: Parts Location
Code See Page
A28 40
B7 B 40
B8 C 40
: Relay Blocks
Code See Page
1 22
: Junction Block and Wire Harness Connector
Code See Page
1H 25
2B 28
2E
28 28
2F
2R 29
: Connector Joining Wire Harness and Wire Harness
Code See Page
IC2 50
: Ground Points
Code See Page
II 50
IJ
50 50
IK
Code
C11
D6
J4
Relay Blocks (Relay Block Location)
Engine Room R/B (Engine Compartment Left)
Junction Block and Wire Harness (Connector Location)
Engine Room Main Wire and Engine Room J/B (Engine Compartment Left)
Instrument Panel Wire and Driver Side J/B (Lower Finish Panel)
Engine Room Main Wire and Driver Side J/B (Lower Finish Panel) Engine Room Main Wire and Driver Side J/B (Lower Finish Panel)
Instrument Panel Wire and Driver Side J/B (Lower Finish Panel)
Joining Wire Harness and Wire Harness (Connector Location)
Instrument Panel Wire and Floor Wire (Left Kick Panel)
Ground Points Location
Cowl Side Panel LH
Instrument Panel Brace LH Instrument Panel Brace LH
2005 CAMRY (EWD586U)
See Page
40
42
41
Code See Page
J23 41
129