Appendix - Toshiba RAS-B10EKVP-E Service Manual

Appendix

No. Part name
13 Power cord
14 Thermostat
fixing plate
15 PVC tube
16 Shield tube
17 Bundling tie
NOTE: The parts on the above table are recommended parts.
2. Required tools for installation work
No. Part name
1 Plus screwdriver
2 Wrench
3 Motor drill
4 Faston crimping tool
5 Close-end connec-
tor crimping tool
6 Cutting plier
7 Stripper
8 Cutter knife
9 Insulation tape
10 Metal-cutting shears
Q'ty
1 2-cores x 0.75mm² or more, H05RN-F
1 Material: SGCC-Z08, Board thickness: 0.8t
1 Inside diameter Ø8 x outside diameter Ø11 x 70 mm
1 Inside diameter Ø18 x outside diameter Ø26 x 70 mm
Material: Polyethylene foam
1 Bundling tie for securing the wires
Material: 6/6 nylon
Specifications
Drill diameter:
Ø3.2 and Ø5.0
Fixing jig for #250
Specifications/Vendor
It is used for disassembling and assembling of each cabinet.
It is used for disassembling and assembling of compressor fixing nuts.
It is used to make the additional holes on the base or the side cabinet
(R).
It is used to process the side cabinet (L).
Appendix-2
Remarks
Procured locally
Procured locally
(Drawing attached)
Procured locally
Procured locally
Procured locally
Usage