Table of Contents
Advertisement
Manual Operation
Manual operation enables the automatic watering pro-
grams or selected zones assigned to the program to be
started manually. During operation, temporary changes
can be made to increase or decrease the zone run
time, step through the zone sequence and pause or
stop watering using the "Watering Control Features"
described on page 32. Upon completion of the manual
watering operation, the timer will return to the Automatic
mode.
Starting Programs and/or Zones Manually
You may operate all zones or selected zones in each pro-
gram. Watering programs can be started individually or
set to start in order. When one program finishes the next
selected program will operate.
Ensure the control dial is in the
Position the
switch to select the program
programs
you wish to start.
Choose one of the following manual operations:
• To operate the selected program with all
assigned zones, press the
button two times to begin watering.
• To operate only selected zones, press the
button, then press the +/
manual start
to select the flashing zone number, or press the
button to skip the zone number. Continue
–/
off
selecting or omitting zones in this manner. When
only the desired zones are displayed, press the
button again to begin watering.
manual start
position.
run
manual start
button
on
Flashing
Flashing
1
Example: Program A is operating. Zone 1 is on and
has 10 minutes of run time remaining.
Program B will start when program A is finished.
4. To select additional programs, repeat steps
Note: Additional programs set to start will operate
one at a time in alphabetical order. Each program
letter will be displayed as it is selected. The program
currently operating is indicated by the flashing pro-
gram letter.
3
3
3
and
.
Hide quick links:
Advertisement
Table of Contents
