Programming The Timer; About The Watering Program Memory; Setting The Current Time And Date - Toro ECXTRA Sprinkler Timer User Manual

Programming the Timer
About the Watering Program Memory
Once programmed, the ECXTRA memory will be
retained for several years without power. Only the cur-
rent time and date information will be lost and will need
to be reset if power is disconnected from the timer for
more than 24 hours.
The ECXTRA has a permanent (default) watering sched-
ule that can operate your sprinkler system automatically
when power is first applied.
The default watering schedule operates as follows:
• Program A has a Calendar watering schedule set to
water every day.
• One program start time is set for 5:00
• A run time of 10 minutes is set for each zone and the
pump start/master circuit will be turned on.
• Programs B and C are turned Off (no watering program
settings).
• Master Valve/Pump Start circuit On/Off is On.
• Season Adjust is 100%
• Pump Delay time is 0 (zero).
If you do not wish to program the timer, you can use
the default watering schedule as is. With the
current time and date set, your ECXTRA will be ready
to operate automatically.
Note: The watering program memory can be reset to the
default program at any time. See "Clearing the Program
Memory" on page 36 for detailed information
Setting the Current Time and Date
5
Turn the control dial to the
position (the hour digits will begin flashing).
Note: The time of day will be displayed in hours and
minutes (12-hour format). To select a 24-hour format,
(5:00).
press the next button repeatedly to display 12 H. Press
am
the +/
once (the hour digits will begin flashing).
To adjust the display, press the +/
the digits forward or the –/
its backward.
Note: The display will begin to change rapidly if either
button is held down for more than two seconds.
Press the
the display.
4. Repeat steps
information: minutes, year, month and day.
When the current time and day are displayed, return
the control dial to the
current time
button to display 24 H. Press the next button
on
off
button to select the next portion of
next
and to set the following current
position.
run
Day
Month
/
day
button to scroll
on
button to scroll the dig-