Appendix C: Configuration Guide; Battery Backed Ram With Real-Time Clock; Addition Format Area; Graphic Images - Microcom 410 Operator's Manual

Printer Commands Chapter 5
))))))))))))))))))))))))))))))))))))))))))))

APPENDIX C: CONFIGURATION GUIDE

The 410 printer must be configured to use some of the special features. The printer can be
configured by Microcom Corporation when ordered or can be configured by the user with
Microcom Corporation parts.

BATTERY BACKED RAM WITH REAL-TIME CLOCK

A battery backed RAM/clock socket is required to utilize the real-time clock capabilities of the
410 printer. This socket should be placed in socket U5 after removal of the RAM chip already in
that socket. The RAM chip should then be inserted into the battery backed RAM/clock socket.
The clock function will not work until initialized with the time and date through command ^D30.
The circuit board must at least be a C rev to use the clock feature. If it is not, the printer may be
sent to Microcom Corporation for a board upgrade.

ADDITION FORMAT AREA

If needed, an extra 32K RAM is available. This option will increase the communications buffer
and add addition RAM which can be used for format and/or graphics storage (see section 5.3.6).
This extra RAM should be inserted into slot U4. If permanent storage is required an additional
battery backed RAM/clock socket (placed beneath each RAM chip - U4, U5) can be used. (Note:
The clock function of the extra RAM socket U4 will be ignored.)

Graphic Images

Logo operation requires the extra 32K RAM and battery backed RAM/clock socket in slot U4. It is
not necessary to battery-back U5 for logos.
))))))))))))))))))))))))))))))))))))))))))))
74 410 Operators Manual