Connecting To Your Computer; Via Usb Cable - Pentax 3 User Manual

Connecting to Your Computer

There are at least two ways to connect your PocketJet to your
computer. USB cable and Infrared (IrDA) are both supported.
Optionally, you can connect via a wireless Bluetooth
connection if your printer is factory-configured for this
method and your computer has Bluetooth installed.

Via USB Cable

CAUTION: Install the driver software before connecting the printer
1. Make sure your printer is off before installing the interface cable.
2. Take the printer end of the cable and hold it so the notched metal
surface is facing up.
3. Insert the printer end of the cable into the interface connector on the
side of the printer. See example, Figure 7.
FIGURE 7. Connecting the PocketJet to your computer
CAUTION: Always insert and remove the interface connector
4. Connect the other end of the cable to the USB port on your
computer.
Note 1: USB is not supported for Windows 95.
Note 2: For Windows 98/98-SE, USB printing requires installing Microsoft's
USBPRINT solution. To install this software:
to the computer via the USB cable.
gently. Press the latching devices on each side of the
interface connector when removing the cable.
Page 16