Filter Time / Service - Hitachi EDP-J32 - LCD Projector Owner's Manual

OPTION menu (continued)
Item
The filter time is the time counted after the last resetting. It is shown
in the OPTION menu as the usage time of the air filter. Performing
this item resets the time.
Pressing the RESET button on the remote control or the button ►
on the projector displays a dialog to make sure.
To perform reset, point at RESET using the button ▲.
FILTER TIME
• Please reset the filter time only when you have cleaned or
replaced the lamp, for a suitable indication about the air filter.
• For the air filter care, please see the section "Air filter". (50)
Choosing this item displays the SERVICE menu.
Choose an item using the buttons ▲/▼, and
press the button ► or the ENTER button to
execute the item.
FAN SPEED
Using the buttons ▲/▼ switches the rotation speed of the cooling
fans.
SERVICE The HIGH is the mode for use at highlands etc.
• Note that the projector is noisier when the HIGH is selected.
• Except for use at highlands, please use setting the NORMAL
mode. The HIGH mode may shorten the lifetimes of the lamp.
AUTO ADJUST
Using the buttons ▲/▼ enables or disables the automatic
adjustment.
Depending on conditions, such as input image, signal cable to the
unit, environment around the unit, etc. the automatic adjustment
may not work correctly.
In such a case, please choose DISABLE to disable the automatic
(to be continued)
adjustment, and make adjustment manually.
RESET  CANCEL
FAN SPEED  AUTO ADJUST  GHOST
FACTORY RESET  FILTER MESSAGE
HIGH  NORMAL
ENABLE  DISABLE
Multifunctional settings
Description
FILTER TIME
0h.
RESET
CANCEL
SERVICE
FANSPEED
AUTO ADJUST
GHOST
FILTER MESSAGE
FACTORY RESET EXECUTE
FANSPEED
HIGH
NORMAL
AUTO ADJUST
ENABLE
DISABLE
:SELECT
NORMAL
100h.
45