Safety Information - GE GXSS17Z01 Installation And Owner's Manual

IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING!
SAFETY PRECAUTIONS
Check and comply with your state and local
codes. You must follow these guidelines.
Use care when handling the water softening
system. Do not turn upside down, drop, drag,
or set on sharp protrusions.
Water softening systems using sodium chloride
(salt) for regeneration add sodium to the water.
Persons on sodium restricted diets should consider
the added sodium as part of their overall intake.
Potassium chloride can be used as an alternative to
sodium chloride.
PROPER INSTALLATION
This water softening system must be properly installed and located in accordance with the Installation
Instructions before it is used.
Install or store where it will not be exposed to
temperatures below freezing or exposed to any
type of weather. Water freezing in the system will
break it. Do not attempt to treat water over 100°F.
Do not install in direct sunlight. Excessive sun heat
may cause distortion or other damage to non-
metallic parts.
Properly ground to conform with all governing
codes and ordinances.
Read and follow this Safety Information carefully.
SAVE THESE INSTRUCTIONS
For your safety, the information in this manual must be followed to minimize the risk of
electric shock, property damage or personal injury.
The water softening system works on 24 volt-60 Hz
electrical power only. Be sure to use only the
included transformer.
Keep the salt hole cover in place on the softener
unless servicing the unit or refilling with salt.
WARNING: Do not use with water that is
microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system.
Use only lead-free solder and flux for all sweat-
solder connections, as required by state and
federal codes.
Maximum allowable inlet water pressure is 125 psi.
If daytime pressure is over 80 psi, nighttime
pressure may exceed the maximum. Use a pressure
reducing valve to reduce the flow if necessary.
WARNING: Discard all unused parts and
packaging material after installation. Small parts
remaining after the installation could be a choke
hazard.
3