Epson Endeavor 468C User Manual page 93

Complete instructions for installing the processor are provided
in the manual that comes with it. Please follow those
instructions carefully, along with the following guidelines:
Although the OverDrive processor User's Guide instructs
q
you to remove the main system board from the computer,
this is not necessary. You can leave the board inside the
computer case while you install the processor.
Refer to the illustration on page 4-3 to locate the
q
microprocessor socket on the system board. You can install
the OverDrive processor (or 487SX chip) directly in this
socket; however, you need to remove the current
microprocessor first. To remove the microprocessor chip,
follow the instructions in the next section.
When you install an OverDrive processor, you need to
q
change the jumper setting of J4 to position A.
After you install the processor and replace the computer's
q
cover, run the SETUP program so your computer can
update its configuration. See Chapter 2 for instructions.
(You need only run the program and save the
configuration; you do not need to change any settings.)
4-22
Installing and Removing Options