Removing A Hard Disk From The Vertical Bay - Epson Endeavor 468C User Manual

Removing a Hard Disk From the Vertical Bay

Follow these steps to remove a hard disk drive from the vertical
drive bay:
1. Disconnect the hard disk drive ribbon cable and power
supply cable from the back of the drive, as shown below.
Grasp the cable connectors and pull them straight out from
the connectors on the hard disk drive so you do not bend
the pins; do not pull on the cables.
2. Remove the retaining screw securing the hard disk drive and
mounting plate to the horizontal drive bays. Then slide the
hard disk drive and mounting plate in the direction of the
arrow, shown in the following illustration, and lift them out
of the computer.
5-14 Installing and Removing Drives