Cleaning The Oven Door - GE JCB905 Owner's Manual And Installation Instructions

The gasket is designed with a gap at the
bottom to allow for proper air circulation.
Do not rub or clean the door gasket—
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it
has become displaced on the door,
you should have it replaced.
Slot
Hinge lock
Pull hinge locks down to unlock.
Removal position

Cleaning the Oven Door

To clean the inside of the door:
s
Because the area inside the gasket is cleaned
during the self-clean cycle, you do not need to
clean this by hand.
s
The area outside the gasket and the door liner
can be cleaned with a soap-filled steel wool or
plastic pad, hot water and detergent. Rinse
well with a vinegar and water solution.
Lift-Off Oven Door
The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. A tool, such as a small
flat-blade screwdriver, may be
required.
Firmly grasp both sides of the door
at the top.
Close door to the door removal
position, which is halfway between
the broil stop position and fully
closed.
Lift door up and out until the hinge
arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door
at the top.
www.GEAppliances.ca
To clean the outside of the door:
s
Use soap and water to thoroughly clean the
top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to clean
the glass on the outside of the door. Do not let
water drip into the vent openings.
s
If any stain on the door vent trim is persistent,
use a soft abrasive cleaner and a sponge-
scrubber for best results.
s
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing acids
may cause discoloration and should be wiped
up immediately. When surface is cool, clean
and rinse.
s
Do not use oven cleaners, cleaning powders or
harsh abrasives on the outside of the door.
With the
Bottom
edge
door at the
of slot
same angle as
the removal
position, seat the
indentation of
the hinge arm
into the bottom
edge of the hinge slot. The notch in
the hinge arm must be fully seated
into the bottom of the slot.
Fully open the door. If the door will
not fully open, the indentation is not
seated correctly in the bottom edge
of the slot.
Push the hinge locks up against the
front frame of the oven cavity to the
locked position.
Hinge
arm
Hinge lock
Push hinge locks up to lock.
Close the oven door.
Hinge arm
Indentation
31