Stamina FUSION 7200 Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 10
NOTE: The RIGHT PEDAL(41) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(41) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is tightened by turning
counterclockwise.
Thread the RIGHT PEDAL(41) into the RIGHT CRANK(36) as shown. Tighten the pedal securely. Select
the RIGHT PEDAL STRAP(42) which has R marked on it. Snap the two hole end to the inside edge of the
RIGHT PEDAL(41). Insert the other end of the strap through the slot and snap the strap to the hook on the
outside edge of the RIGHT PEDAL(41). Select adjustment holes which allow your foot to be easily removed
from the pedals.
Use the same procedure to attach the LEFT PEDAL(39) to the LEFT CRANK(35) and snap the LEFT
PEDAL STRAP(40) to the LEFT PEDAL(39).
STEP 11
Slide the UPRIGHT SLEEVE(32) over the UPRIGHT(3). Connect the CONNECTION WIRE(26) to the
CONTROL WIRE(25). Insert the UPRIGHT(3) onto the FRONT FRAME(1) and secure with FLAT HEAD
BOLTS(M8x1.25x15mm)(79). Slide the UPRIGHT SLEEVE(32) down to cover the bolt heads.
11