For Canadian Users - Epson C82312 Series User Manual

FCC COMPLIANCE STATEMENT
This equpment has been tested end found to comply wth the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules,
reasonable protection against harmful interface in, a residential installation This
equipment generates, uses, and can radiate radio frequency energy and, If not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guaranee that interference will not occur in a
particular installation If this, equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment oft and on, the
user is, encouraged to try to correct the interference by one or more of the following
measure:
— Reorient or relocate the receiving antenna
— Increase the separation between the, equipment and receiver
— Connect, the equipment into, an outlet on, a, circuit different from that to which the
receiver is connected
— Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules Operation is subject to the
following two conditions:
(I) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired opreration
This, digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the radio interference regulation, of the Canadian
Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioelectriques dépassant les
limites applicables aux appareils numériques de Class B prescrites dans le règlement sur
le broullage radioélectriqus édicté par le Ministere des Communications du Canada.
The connection, of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this, device and may cause interference levels which
exceed the limits established by the FCC for this equipment It is the responsibility of the
user to obtain and use a shielded equipment interface cable with this device If this
equipment has more than one interface connector, do not leave cables connected to
unused interfaces
Changes or modifications not expressly approved by Epson America, Inc , could void
the user's authority to operate the equipment
Seiko Epson Corporation shall not be liable against any damages or problems arising
from the use of any options or any consumables products other than those designated as
Original Epson Products or Epson Approved Products by Seiko Epson Corporation.
FOR AMERICAN USERS

FOR CANADIAN USERS

WARNING
These limits art designed to provide