Sony Walkman WM-FX221 Getting Started Manual

Featuring
3-810-567-14(1)
AVLS (Automatic Volume Limiter System)
The AVLS switch allows you to limit the maximum
volume of your Walkman personal stereo without
degrading the sound quality.
Radio Cassette Player
•When the AVLS switch is set to ON (around 85 dB), the
-
FX221/FX227/FX229/FX421/
WM
volume will be kept at a moderate level without the
FX421V/FX423/FX425 degradation of the sound quality, even if you attempt to
turn the volume up higher.
Operating Instructions
•When the AVLS switch is set to ON, the playback
sound may be distorted or unstable according to the
WALKMAN is a registered trademark of Sony Corporation.
music (especially bass boosted part). If this happens,
Sony Corporation © 1995 Printed in Malaysia
turn down the volume.
•When the AVLS switch is turned off, you will be able to
enjoy the full volume capability of your Walkman
The illustrations in this manual are for the FX425.
personal stereo.
The differences in appearance or operation between each
models are described in the respective sections.
OWNER'S RECORD
The model number is located at the bottom and the
serial number is located inside the cassette holder.
Record these numbers in the spaces provided below.
Refer to them whenever you call upon your Sony
dealer regarding this product.
Model No.
Serial No.
For the customers in the U.S.A.
INFORMATION
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
Getting Started
Using with Batteries
Insert two AA (R6) batteries in correct polarity.
AA (R6) x 2
DC IN 3V
Notes
• When you are not going to use your Walkman for a long time,
remove the batteries to prevent damage from battery leakage and
corrosion.
• When the batteries become weak, the sound will be unstable or can
not be heard. In such a case, replace both batteries.
• Replace both batteries while the E indication comes on in the
display, or all the memories will be canceled.
• Concerning the battery life, see "Specifications".
Using External Power Sources
You can connect the following external power sources
through the DC IN 3 V jack located on the right side.
(When you plug a cord into the DC IN 3 V jack, the
internal batteries are automatically bypassed.)
•House current using an AC-E30HG AC power adaptor
Note
Use only the recommended AC-E30HG
AC power adaptor (not supplied). Do
FX425 not use any other AC power adaptor.
Polarity of the plug
Setting the Clock
Playing Cassette
ENTER
HOUR
MIN VOL
2 2
FX425
1 1
ENTER
Press the ENTER Insert a cassette.
button to enter the
current time setting
mode.
2
HOUR
Set the time by
2
Select the NORM or
using the HOUR/ MINUTE
CrO /METAL mode to
MINUTE buttons 2
match the tape type.
within ten seconds
of flashing.
To set the hour use the
HOUR button and to set the
minute use the MINUTE
3
button. Press the 9 PLAY
button.
3
ENTER
Press the ENTER
button to return to
the current time
display.
Notes
• The hour display does not advance even when the minute display
returns to "00" after "59".
• The hour display is on a 12-hour cycle (U.S.A., Canada and Central
and South America models).
The hour display is on a 24-hour cycle (other models).
Operating the Cassette Player
To wind the tape
NORM CrO /METAL
2
To adjust the volume
p STOP MODE
To stop
0 )
DIR
To change sides*
To play both sides once*
To play both sides repeatedly*
* FX421/FX421V/FX423/FX425 only
Notes on playing cassettes
• Do not use cassettes longer than 90 minutes except for long
continuous playback.
• If the tape is playing but no sound comes out, the batteries may be
weak. Replace all batteries with new ones.
• If your Walkman has not been used for a long time, run the
Walkman for a few minutes before inserting a cassette.
• Do not open the cassette holder while the tape is running.
Using MEGA BASS
FX425 (FX227/FX229/FX423/FX425)
Set the MEGA BASS selector to ON to produce deep and
powerful sound.
9 PLAY
When using MEGA BASS
If the AVLS switch is set to ON, the MEGA BASS effect is
reduced.
NORM CrO 2 /
Using DOLBY NR (FX425)
METAL
TAPE
Set theDOLBY NR switch to ON to play Dolby NR
processed tapes.
PLAY
Press 0 or ).
Set the VOL control.
Press p STOP.
Set DIR to ª or ·.
Set MODE to Å.
Set MODE to a.
FX227/FX229/
FX423
ON
OFF
FX425
MAX
MID
NORM