Advertisement
Press in on the top of the battery cover on the back of the remote
control. Then slide the cover down and off the remote.
Insert the batteries as shown here, making sure the + and – ends
face the right way. Then push them down flat.
Place the cover into the grooves and slide the cover all the way up
until it clicks into place.
Press and release the printer cover latch to open the cover.
Flip down the printer lock cover and turn the lock counterclockwise to loosen it. It spins freely when
it is unlocked.
Grasp the printer handle and pull the printer out as far as it goes.
Pull open the ink cover on the side of the printer.
Remove the cassette from its package. Then remove the red paper strip from the end.
If the ink ribbon is slack, rotate the spindles to tighten it.
Position the cassette as shown below, on the right.
Carefully align the cassette and its ribbon with the slot, then gently
push in the cassette until it clicks into place beneath the latch.
You must align the cassette and its ribbon with the slot or
you will damage it when you slide it in.
Flip up the ink cover and push it closed.
Slide in the printer until it stops.
Push in on the printer lock as you turn it clockwise to tighten it.
If it doesn't tighten, push the printer in further and try again.
Flip up the lock cover.
Make sure to lock the printer securely and close the lock cover completely
or the printer won't print.
+
+
Pointed plastic tab
should face up
Covered ends of the
ribbon should face out
Advertisement
