Table of Contents
Advertisement
Available languages
Available languages
UNPACKING
This product requires assembly
[] Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
A
WARNING:
This new product
has been shipped
in a partially
assembled
condition
as described
below.
Carefully
check
the
packing
list below
to ensure
all items are included
in the package;
the
packing
list describes
all loose
items
that
are not assembled
to the product
as shipped.
Do not operate
the product
if any packing
list
items
are already
assembled
to your
product
when you
unpack
it. Call the customer
service
number
below
for
assistance.
Operation
of a
product
that may have been improperly
preas-
sembled
could
result in serious
personal
injury.
[]
Inspect
the product
carefully
to make sure
no
breakage
or damage
occurred
during
shipping.
[] Do not discard the packing material until you have care-
fully inspected and satisfactorily
operated the product.
[] If any parts
are damaged
or missing,
please
call
1-800-932-3188
for assistance.
PACKING
LIST
Hedge Trimmer
Debris Deflector
Deflector Retainer
Blade Sleeve Cover
Operator's Manual
A
A
WARNING:
If any parts are damaged or missing, do
not operate this product until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended
for use with
this product. Any such alteration or modification
is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
_b,
WARNING:
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
ASSEMBLING
THE TOOL
See Figure 3, 4 page i and ii,
Before using the extended reach hedge trimmer, a one-time
assembly is required.
[] The rear handle and trimmer head come unassembled.
[] Remove the rubber cord protectors from the trimmer head
base and the rear handle. Position trimmer head and rear
handle as shown in figure 3.
[] Unscrew the threaded collar from trimmer head base by
rotating it counterclockwise
and pull back over the cord
to the rear handle as shown.
[] Insert the rear handle into the trimmer
head threaded
base until the lock holes click into place. The tubes are
egg-shaped
and will only install one way. The threaded
base will spread open during assembly.
NOTE: You may need to slightly rotate tube from side to
side until it locks into place.
[] Lower the threaded collar onto the threaded base and
rotate clockwise to secure.
_t,
WARNING:
Failure to lock the rear handle into the
trimmer head base as directed above could result in
serious injury or death.
[] Do not operate until assembly is completed.
8 - English
Advertisement
Table of Contents
