Direction Of Rotation - Craftsman C944.414460 Instruction Manual

Inside view o f
/# C_ain Brake
Adjustment located on Chain Brake
5. Turn adjusting screw by hand
counterclockwise until adjusting pin
just touches the stop.
6. Slide guide bar behind clutch drum
until guide bar stops against clutch
drum sprocket.
7. Carefully remove new chain from
package. Hold chain with the dnve
links as shown,
Tip of
Bar
DIRECTION OF ROTATION
Cutters Depth Gauge
Drive Links
8. Place chain over and behind
clutch, fitting the drive links in the
clutch drum sprocket,
9. Fit bottom of drive links between
the teeth in the sprocket in the
nose of the guide bar.
10. Fit chain drive links into bar
groove.
11. Pull guide bar forward until chain is
snug in guide bar groove, Ensure
all drive/inks are in the bar groove.
12. Install chain brake making sure the
adjusting pin in positioned in the
lower hole in the guide ba£
Chain [q_ _f_ I_
Brake
,
,
_:_ Hole /
Adjushng Pin Guide Bar
13. Install chain brake nuts and finger
tighten only. Do not tighten any fur-
ther at this point. Proceed to
CHAIN ADJUSTMENT
CHAIN ADJUSTMENT
See CHAIN TENSION in ASSEMBLY sec-
tion,
CARBURETOR ADJUSTMENT
,_.WARNING: The chain wilt be
moving during most of this procedure,
Wear your protective equipment and
observe all safety precautions. The
chain must not move at idle speed.
The carburetor has been carefully set
at the factory. Adjustments may be
necessary if you notice any of the fol-
lowing conditions:
• Chain moves at idle. See IDLE
SPEED-T adjusting procedure.
• Saw wilt not idle. See IDLE SPEED-T
adjusting procedure.
Idle Speed-T
Allow engine to idle. If the chain
moves, idle is too fast. If the engine
stalls, idle is too slow. Adjust speed
until engine runs without chain move-
ment (idle too fast) or stalling (idle too
slow). The idle speed screw is located
in the area above the primer bulb and
is labeled T.
• Turn idle screw (T) clockwise to in-
crease engine speed.
• Turn idle screw (T) counterclockwise
to decrease engine speed.
If you require further assistance or are
unsure about performing this proce-
dure, contact your Sears Service
Centre.
18