Craftsman 919.670040 Owner's Manual page 10

GROUNDBNG
THE GENERATOR
A grounding lug is supplied with the generator for use
when required by local electrical ordinances. Refer to
article 250 of the National Electrical Code to clarify
any needed grounding information. Your local electric
company or a certified electrician should be able to
help you with this information.
NOTE: Your engine is already grounded to the frame
by a grounding strap.
Grounding Lug
mNSTALUNG WHEEL KmT
The Craftsman Wheel Kit was designed to greatly
improve the portability of your generator.
Drain gas and oimbefore
assembming the portabimity
kit. Faimure to do so wimm cause damage to the
engine.
NOTE: Always follow state regulations for proper oil
disposal.
Place generator on level ground; drain all gas and
oil from the engine (see engine manual for correct
procedure).
Place a 1" thick x 1' square piece of wood on the
ground in front of the engine. With the help of
another person, tilt the generator and rest the
recoil starter on the wood. NOTE: This will
support the gasoline engine during assembly and
@
o
Place a handle cap (7) onto each end of handle
prior to installation.
The handle should be installed on the electrical
outlet end of the generator. Place one washer
(12) on long cap screws (11). Align the handle
brackets with the upper hobs pre-drilled in the
generator frame. Place mentioned screws through
frame and handle brackets. Secure with lock nuts
(8) and tighten.
o Locate the engine support. Place one wheel
bracket (4) on top of support as shown in iiiustra-
tion. Align with the pre-drilled hobs in support.
Place 2 cap screws (9) through holes in bracket
and support. Secure with 2 lock nuts (8) and
tighten.
Insert one shoulder bolt (2) into wheel (1). Insert
threaded end of bolt through wheel bracket,
secure with lock nut (8) and tighten. NOTE: The
wheemwimm not rub frame if inatammed propermy.
* Repeat the above steps for the opposite side.
Insert the threaded stud of rubber foot (10)
through the middle hob of the foot bracket (5)_
Secure with lock nut (8) and tighten.
Locate the support under the electrical outlet end
of the generator. Position foot bracket (5), with
rubber foot installed, under the support and align
the hobs in the foot bracket (5) with the dots in
the support. Place one cap screw (9) through
each dot in the support and the hobs in the foot
bracket. Secure with the lock nuts (8) and tighten.
Once completed, the wheel kit is ready for use.
6
/
/
/
11
12
b1<_p 67oo4o 10 -- ENG