Handle Attachment; Tube Assembly - Craftsman 257.798031 Operator's Manual

ASSEMBLY
If your unit is received assembled, repeat all steps in this seetion to be sure assembly is correct and is
adjusted for the operator.)
PREPARATION
This Operator's Manual is designed to help you assembh a_d safely operate this u_it. It is important thatyou read the
entire manual to become familiar with the tool before you begin assembl_
TOOLS NEEDED FOR ASSEMBLY."
1. Phillips Screwdriver
2. Adjustable Wrench
A. ASSIST HANDLE ATTACHMENT
I. Passthewireharness t hroughtheslot]n thebot-
tom oftheYoke.Figure i (inset).
2. Slide theYoke ontotheUpper Tube as shown in
Figure 1 (inset).
3. Place theAssist H andleover theYoke. Assemble
parts as shown inFiguze I.
4. Placetheboltin theAssistHandle. Figurei.
ThreadtheKnob ontothebolt and tighten until t he
parts are snug.
Figure1
u i ii i i ,i ,,,, , H HHHI ,I ,I IIIIIr
B. TUBE ASSEMBLY
1. Insert theLower Tube intothe Outer Tube and
align scre_r holes. Figure 2.
2. Insert the two screws, one at a time, through the
aligned holes.Figure 2. Thread I.eclmut onto
screws and tighten securely.
3. Foldthewireharness and push it intotheLower
Tube. Figure 2 {inset). Y_the wire harness is not
rlong enough to fold, s imp!y push excess wireinto
thetube.
4. Insert the OuterTube over the Upper tube and
align screw holes. Figure 2.
5. Insert the two screws, one at a time, thxough the
aligned holes. Figure 2. Thread Lo_-l_ut onto
screws and tighten securely. •
Lower
Tube
C= S.HT_,Ln A qMrACHMENT
A WARNING I
The shieId must be properly installed. The[
shield provides partial protection from the r_kI
of thrown objects _ the o]_. rator and others mad [
iS equipped with a llne Iimiter which cuts line to ]
the proper length. I "
Screw------_y
Umiter
Screw
Holes