Installing And Adjusting The D-Handle - Craftsman WEEDWACKER 316.796140 Operator's Manual

INSTALLING AND ADJUSTING THE D-HANDLE
To Install
Place the D-handle down on to
the shaft housing and the boffom
clamp so that the handle slants
toward the shaft grip (Fig. I).
Place handleand clamp a
minimum of 6 inches from the
end of the shaft grip.
2. Start screws with a large Flat-
head or T-25 Torx screwdriver.
Do not tighten until the handle is
adjusted.
To Adjust
3. While holding the unit in the
operating position (Fig. 2),
postion the D-handle to the
location that provides you the
best grip.
4.
Fig. 2
Tighten the clamp screws evenly, until the D-handle is
secure.
4L_
INSTALL LINE TRIMMER ATTACHMENT
NOTE: To make installation easier, place the unit on the
ground or on a workbench.
1. Turn knob counterclockwise to loosen coupler (Fig. 15, p.
8).
2. While firmly holding attachment, push it straight into the
coupler until the release button snaps into the primary hole
(Fig. 16, p. 9J.
NOTE: Aligning the release button with the guide recess (Fig.
16, p. 9)will help installation.
3. Turn the knob clockwise to tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative
tdmming around trees, fences, etc.
Spark Oil Fill Plug
Muffler _._ug [
Shaft Grip Cap Choke
On/Off Stop Lever
Control .P._X'_ _ _P Czk_
_ X 'S tar tSI_:_r_l_ r
D-Handle Rope
Grip
Twist & Edge
Convertible
TM
I Throttle
Couple// Air Filter Primer
Cover Bulb
Shaft
Housing
Line
Cutting
Blade
_A Cutting
ttachment Shield
HassleFree IIF M
On/Off Stop Control
Shaft
Housing
Shaft Grip
Minimum 6 Inoh_
(15.24 ore)
D-Handle
(4) Screws
Fig, 1