Installing And Adjusting The D-Handle - Craftsman WEEDWACKER Incredi-Pull 316.796140 Operator's Manual

INSTALLING AND ADJUSTING THE D-HANDLE
To Install
1. Place the D-handle down on to
the shaft housing and the bottom
clamp so that the handle slants
toward the shaft grip (Fig. 1).
Place handle and clamp a
minimum of 6 inches from the
end of the shaft grip.
2. Start screws with a large Flat-
head or T-25 Torx screwdriver.
Do not tighten until the handle is
adjusted.
To Adjust
3. While holding the unit in the _,
operating position (Fig. 2),
postion the D-handle to the
location that provides you the
best grip.
4.
Fig. 2
Tighten the clamp screws evenly, until the D-handle is
secure.
INSTALL LINE TRIMMER ATTACHMENT
NOTE: To make installation easier, place the unit on the
ground or on a workbench.
1. Turn knob counterclockwise to loosen coupler (Fig. 15, p.
8).
2. While firmly holding attachment, push it straight into the
coupler until the release button snaps into the primary hole
(Fig. 16, p. 9).
NOTE: Aligning the release button with the guide recess (Fig.
16, p. 9) will help installation.
3. Turn the knob clockwise to tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative
trimming around trees, fences, etc.
Spark Oil Fill Plug
Muffler _,_ug /
Fuel
Shaft Grip __" Fu; Choke
On/Off Stop_ :_ _ Lever
Control "_t_'_ _ _ _ _'_
D-Handle _,_'_' _Sta;eer "_-_
Starter r_
\ /? F//
Twist & Edge "_---._,. X v_ / _lJ
ac%dnCvratiff_lemT an _ Throttle, -
Y I"
_// Air Filter _Prime _°ntrol r
Coupler
""_/ Cover Bulb
Shaft _._
Housing /_
"_= // Line
"_// Cutting
_ Blade
"" _Atta chCUtet_gshield
HassleFree III
TM
On/Off Stop Control
Shaft !
Housing
Shaft Grip
Minimum 6 Inches
(15.24 cm)
D-Handle
Fig. 1
(4) Screws
Bottom Clamp