Craftsman 917.249660 Owner's Manual page 10

CONTAINER ASSEMBLY (See Fig. 5)
1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lift top half to
meet bottom half.
3. Press halves tightly together while lifting top to lock
into place as shown.
IMPORTANT:BEFORELOCKING THETABS, HOOKED EDGES
ON BOTHHALVESMUSTOVERLAPTOFORMSEAL AS SHOWN
IN INSET.
4. Repeat for other containers.
CONTAINER
BOTTOM HALF
CONTAINER
TOP HALF
PRESS TOGETHER
TO FORM SEAL
CONTAINER WHILE UFTING
TOP HALF TOP HALF
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 5
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
CONTAINER MOUNTING
(See Fig. 6)
No hardware
required
• Install one container to left side first with warning to
outside of unit. Install another container center position
and one in right position.
NOTE: Right container should always overlap left container
at center supports.
• Close cover and lock latch handles over center support
tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER
SUPPORT.
TUBES
CONTAINER
HANDLE
WARNING
FIG. 6
10