General Information; Model Description; Unpacking And Checking Contents - Sears Craftsman 113.248211 Owner's Manual

general information
BOTH MODELS
1. This manual is 1or the following Models - 113.248211
and 113,248321. All sections are labeled with the
correct model number. Follow ONLY instructions
that are meant for your model saw.
2. If you are missing anypart(s) while putting your saw
together, do not continue assembly. Contact your
Sears Service Center or Retail Store and get the
missing part(s) before continuing assembly or trying
to use the saw.
Complete parts lists are located at the end of this
manual. Use these liststo identify the number of any
missing part.
3. Sometimes small parts get lost in packaging materi-
als. Do not throw away any packaging until your saw
is put logether. If you are missing a part, check
packaging before contacting Sears.
MODEL DESCRIPTION
MOdel 113.248211: Manual Band Saw; 18 x 23 inch
Work table; single speed; 1/2 HP. motor that develops
1 H.P.; legset.
Model 113. 248321: Manual Band Saw; 27 x 23 inch
work table; two speed; 5/8 HP. motor that develops
1-1/8 H.P.; legset.
unpacking and checking contents
BOTH MODELS
TOOLS NEEDED
MEDIUM SCREWDRIVER
_' _....... 3/8" WRENCH
7/16" WRENCH
COMBINATI 9/16" WRENCH
SQUARE_
7/16" SOCKET
9/16" SOCKET
1/8" HEX "L" WRENCH R_
5/32" HEX "L" WRENCH _ SOCKET WRENCH
COMBINATION SQUARE MUST BE TRUE
f
STRAIGHT EDGE OF
BOARD 3/4-INCH THICK
THIS EDGE MUST BE
PE_CTLY STRAIGHT
DRAW LIGHT
LINE ON BOARD
ALONGTHIS EDGE _,,_ J
SHOULD BE NO GAP OR OVERLAP HERE WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
WARNING: To avoid Injury from unexpected
starting or elect rical shock, do not plug the saw in
until all assembly and alignment steps are com-
plete. The power cord must remain unplugged
whenever you are working on the saw.
Unpacking and Checking Contents
1. Separate all "loose parts" from packaging materials
and check each item with "Table of Loose Parts" to
make sure all items are accounted for, before discard-
ing any packing material.
l WARNING: If any parts are missing, do not at-
tempt to assemble the band saw, plug in the
power cord, or turn the switch on until the missing
parts are obtained and are installed correctly.
2. Remove front table and front cover first while saw is
being unpacked. To remove the front cover, pull the
cover at the neck and underside of throat area.