Sears Craftsman 113.248211 Owner's Manual page 25

O
4. Locate the two (2) table latches, two (2) 3/8"long Phil-
lips head self tapping screws, two (2) small washers,
and one (1) large washer.
5. Place front table latch through slot on right side of
handsaw frame.
6. Tilt top of front table latch slightly forward and place
large washer between bracket and handsaw frame.
7. Place self tapping screw through small washer and
attach to table latch. Do not completely tighten
screw.
8. Attach left side table latch with self tapping screw
and washer as shown.
SMALL
WASHER
PHILLIPS HEAC
SELF TAPPING
SCREW
_l_-_ TABLE LATCH
, LARGE
WASHER ON RIGHT
"\ ix SIDE ONLY
\.
/
\ ! TABLE LATCH
SMALL WASHER-_..._,"_ j"
7
BASE
PHILLIPS HEAD
SELF TAPPING
SCREW
ASSEMBLE WITH LATCH TO
HIGHEST ADJUSTING POSITION
0
9. Locate the table alignment key and the two (2) 1/4-
20 x 5/8 low head capscrews. Install the key under
the rear table miter gage slot and install the two
screws but do not tighten at this time.
_CAPSCREW
AL, ..E.T
10. Mount the front table to the base as follows:
a. Make sure front table latches are positioned up as
high as they will go.
b. Hold the front edge of the table. Position the rear
edge of the table so that the two flat springs slip
under the two tabs on the rear table.
c. Line up the miter gage slots in the front and rear
tables.
d. Push the front edge of the table backward and
downward until the table snaps into position.
FRONT TABLE
\
Q
25